磁力冷凝器出廠前氣壓試驗方法

磁力冷凝器出廠前要進行有關的氣壓實驗的目的是查看高壓冷凝器有關性能及安全性，其詳細施行進程為： 磁力冷凝器做氣壓實驗的氣體為幹燥清洗的空氣、氮氣或別的惰性氣體。實驗進程中應有安全措施，實驗單位的安全管理部門應當在現場進行監督監管。磁力冷凝器做氣壓實驗進程如下：實驗時應先緩慢升壓至規則實驗壓力的10%，保壓5分鐘後，對所用焊接接頭盒銜接部位進行查看。在確認上述部位沒有走漏後，持續升壓至規則實驗壓力的50%。
上述進程中無異常現象，這以後按規則實驗壓力的10%逐級升壓，直到實驗壓力，保壓10分鐘。最終將至高壓冷凝器的設計壓力，保壓滿足時刻進行查看，查看時期其壓力應堅持不變，如有變化證實高壓冷凝器中有漏氣部位，應檢查並解決。
The purpose of the pressure test to becarried out before leaving the factory is to examine the performance and safetyof the high pressure reaction kettle:
Magnetic reaction kettle gas pressure testis done for dry cleaning air, nitrogen or other inert gases. In the course ofthe experiment, there should be saf印花地坪ety measures, the experimental unit of thesafety management department should be in the field of supervision andregulation.
Magnetic reaction kettle to do the pressuretest（www.gfanyingfu.com） process is as follows:
In the experiment, 彩色沥清地坪the pressure of the ruletest should be boosted to 10%, and the joint part of the welded joint boxshould be checked after 5 minutes.
In the confirmation part without leakageafter continuous experimental pressure boost to rule 50%.
There is no abnormal phenomenon in thecourse of the above process, which will step by step up to 10% step by stepaccording to the experimental pressure of the rule, and keep the pressure for10 minutes. Finally, the design pressure of the high pressure reactor, thepressure to meet the moment to view, check the pressure should adhere to thesame period, if there is a change in the high-pressure reaction tank to confirmthe leak site, should be checked and resolved.
辛苦整理！轉載請註明來自http://www.zqshzb.com/n1b/3024.html