廠傢解讀熱風爐的檢修安全方法

下面為大傢介紹熱風爐成都收賬檢修安全方法。首先，檢修熱風爐時，應用盲板或其他可靠成都找人公司切斷裝置防止煤氣從鄰近煤氣管道竄入，並嚴格執行操作牌制度；煤氣防護人員應在現場監護。其次，進行熱風爐內部檢修、清理時，應遵守下列規定；
The following is to introduce the hot stove repair safety methods. First, when the hot air stove is overhauled, the blind board or other reliable cutting devices are used to prevent the gas from channeling from the adjacent gas pipeline, and the operating card system is strictly enforced; the gas protection personnel should be monitored on the spot.
Secondly,印花地坪 the following regulations should be observed when the internal maintenance and cleaning of hot blast stoves are carried out.
1、煤氣管道應用盲板隔絕，除煙道閥門外成都收賬所有閥門應關死，並切斷閥門電源；
1. Gas pipeline shall be insulated by blind plates. All valves except flue valves shall be closed and the power supply of the valves shall be cut off.
2、爐內應通風良好，一氧化碳濃度應在24ppm以下，含氧量應在18%～21%（體積濃度）之間，每2h應分析一次氣體成分。
2, the furnace should be well ventilated, carbon monoxide concentration should be below 24ppm, oxygen content should be between 18% and 21% (volume concentration), each 2H should be analyzed a gas composition.
3、修補熱風爐隔墻時，應用鋼材支撐好隔棚，防止上部磚脫落。
3. When repairing the partition wall of hot blast stove, steel should be used to support the partition shed to prevent the upper brick from falling off.
最後，熱風管內部檢修時，應打開人孔，嚴防煤氣熱風竄入。
Finally, the manhole should be opened when the hot air pipe is repaired, and环氧地坪 the gas hot air should be strictly prevented.
以上是熱風爐收賬檢修安全方法介紹。歡迎您前來選購我們成都找人公司產品！
The above is the introduction of the safety methods for the maintenance of hot blast stove. Welcome you to come and buy our products!