廠傢為您講解用熱風爐時需要註意什麼

熱風爐不同於普通成都收賬實驗電爐,其在結構以及使用上都具備特殊性,為瞭更好成都找人公司保證安全使用,也使其盡可能成都收賬發揮果效,有以下收賬操作註意：1.熱風爐爐芯位置確定要準確,反應箱必須垂直吊放,高度適中,放置端正,兩排箱體之間保持等距,定保爐芯寬度尺寸精確無誤.反應箱四角與端墻縫隙處,用紙填實.Hot-blast stove is different from ordinary experimental electric stove. It has special structure and use. In order to ensure its safe use and make it as effective as possible, the following operation should be noted:1. The position of the hot blast stove core should be determined accurately. The reaction box must be placed vertically, with a moderate height, and placed correctly. The width of the hearth should be kept equidistant between the two rows of boxes. The gap between the corner of the reaction box and the end wall should be filled with paper.2.開車前檢查熱風爐成都找人公司軌道有無障礙物,鋼絲繩、卷揚機、托輪、小托車必須完好,並按規定加油潤滑.2. Check the track of the hot blast stove before starting. The wire rope, hoist, bracket and trolley must be intact and lubricated according to the regulations.3.開車人員必須聽從裝爐操作人員指揮,密切配合.放置爐底乏料,要用鋼尺插量三點(兩端及中間),按規定尺寸檢查,爐頭四角的乏料要裝足踩實,防止流鹽燒墻.3. Drivers must obey the instructions of furnace loading operators and cooperate closely. Lack of material at the bottom of the furnace should be placed, three points should be inserted with a steel ruler (both ends and the middle), inspected according to the prescribed size, and the material at the four corners of the furnace should be fully stepped on to prevent wall burning by flowing salt.4.每放完一部爐料後,料鬥閉合器要關嚴密.爐料裝完後,灑在端墻拉桿上的乏料或石墨要清理幹凈,卷揚機小車停放在安全位置,壓起頂軸,用蓋蓋好,並將所裝爐號及裝爐異常情況填入工藝卡片,隨爐傳送托車組.4. The hopper closer should be closed tightly after each charge is put in. After the charge is filled, the waste material or graphite sprinkled on the end wall tie rod should be cleaned up. The winch trolley should be parked in a safe position,彩色沥清地坪 the top axle should be pressed up, and the top axle should be covered properly. The furnace number and the abnormal condition of the furnace should be filled into the process card and transmitted to the trolley with the furnace.5.吊反應箱時,應指揮吊車擺正位置,垂直提升.須待箱體全部撥出後,才能開動熱風爐大車吊环氧地坪走.嚴禁熱風爐的爐車在運行中吊反應箱.放反應箱時,按順序擺放.裝爐工應將去掉的四鏈鉤放於箱體之內,以免起鉤時掛住外沿使箱體移動位置或箱體碰傷操作人員.5. When hoisting the reaction box, the crane should be directed to put it in the right position and lift it vertically. The hot blast stove truck can only be hoisted until the box is fully removed. It is strictly forbidden to hoist the reaction box during operation. When placing the reaction box, the reaction box should be placed in sequence. The loader should place the four-chain hook removed in the box so as not to hang the outer edge of the box to make the box move when hoisting the hook. Bruise the operator with a set or a box.