环氧地坪漆施工前需做的準備包括哪些？

环氧地坪漆重新建造後會發生什麼？首先，在环氧地坪施工開始時必須保持地面幹燥，不要繼續在不幹的地面上工作。當地板塗料被塗上時，用幹凈的佈清潔表面，以除去表面的濕氣。選擇配套膩子和配套底漆，不要用蟲膠漆底漆和酸固化底漆。在环氧地坪漆膜開始膨脹，膨脹後被擊倒，選擇引物完成底漆二層，然後重新粉刷油漆。其實有很多解決辦法，但最基本的保養就是最好的地板方式。环氧地坪漆在低溫條件下會發生什麼？在低溫下，环氧地坪漆的粘度增加瞭一倍。
What happens when epoxy floor paint is re built? First of all, it is necessary to keep the ground dry at the beginning of the epoxy floor construction and not continue to work on the non-working ground. When floor coating is applied, clean the surface with clean cloth to remove moisture from the surface. Choose matching putty and matching primer, do not use shellac primer and acid curing primer. When the epoxy floor paint film begins to expand and is knocked down after expansion, the primer is selected to finish the second layer of primer, and then the paint is repainted. In fact, there are many solutions, but the most basic maintenance is the best floor mode. What happens to epoxy floor paint at low temperatures? At low temperatures, the viscosity of epoxy floor paint doubled. 在低溫條件下會使自流平不能自然平整地面，XX环氧地坪漆由於粘度太高，而人在找平時會出現劃痕，嚴重影響使用效果。
U透水地坪nder low temperature conditions, self-leveling can not smooth the floor naturally. XX epoxy floor paint has high viscosity, and people will scratch in peacetime, which seriously affects the use effect.
由於在固化反應緩慢，或完全不能治愈，塗抹效果會有一定程度的降低，溫度越低效果較差，可以脫離地面，所以低溫施工是地板上的一個重要組成部分，它是更好地在建設5度以上，雖然外觀可以做出一些補救措施，但會影響地板的使用壽命，所以最好不要在低溫下進行施工。
Because the curing reaction is slow or can not be cured at all, the application effect will be reduced to a certain extent, the lower the temperature, the worse the effect, can be separated from the ground, so low-temperature construction is an important part of the floor, it is better in the construction of more than 5 degrees, although the appearance can make some remedial measures, but it will affect. The service life of flooring is best, so it is best not to carry out construction at low temperatures.
环氧地坪的特點和施工流程
Characteristics and construction process of epoxy floor
环氧地坪公司擅長环氧环氧地坪，各類环氧地坪項目全案設計及實施。
Floor company specializes in epoxy floor, all kinds of epoxy floor project design and implementation of the whole case.
环氧地坪特點：
Epoxy floor features:
1、防潮，防塵；
1, moisture-proof and dustproof;
2、整體無縫，易清潔；
2, the whole seamless, easy to clean;
3、抗沖擊，高荷載；
3, impact resistance and high load;
4、維護方便，成本經濟；
4, maintenance is convenient, cost economy;
5、可做防滑或啞光效果。厚度從0.3-0.5mm起，通常為1mm,2mm,3mm,厚度主要取決於素地情況及承載量，越厚整體性能越好。
5, can do anti slip or matte effect. Thickness is from 0.3 to 0.5 mm, usually 1 mm, 2 mm, 3 mm. Thickness mainly depends on the condition of plain land and load capacity. The thicker the overall performance is, the better.
环氧地坪施工流程：
Epoxy floor construction process:
①素地處理：依據素地狀況進行打磨、除塵、修補；
(1) plain land treatment: grinding, dedusting and repairing according to the condition of prime soil.
②环氧底漆：采用滲透性及附著力特強环氧底漆批塗一遍，增強表面附著力；
(2) Epoxy primers: epoxy primers with strong penetration and adhesion are batched once to enhance surface adhesion;
③环氧砂漿：底塗固化後將調配好的石英砂材料用鏝刀均勻批塗；
Third, epoxy mortar: after the bottom coating is solidified, the well made quartz sand material is uniformly smear coated with a trowel.
④环氧中塗：將环氧樹脂調配好後，用鏝刀將其均勻批塗；
(4) epoxy coating: evenly mix epoxy resin with a t彩色沥清地坪rowel.
⑤环氧膩子：依據實際需要，要求達到平整無孔洞，無批刀印以及打磨印為準；
Epoxy putty: According to actual needs, it is required to be flat without holes, no batch of knife prints and grinding prints.
⑥环氧面漆：將調配好的面塗漆用滾筒均勻的塗層一遍，完工後整體地面光亮潔凈、顏色均一，無空鼓；
Epoxy topcoat: The prepared topcoat is coated once with a uniform roller. After completion, the whole ground is bright and clean, uniform in color and no empty drum.
⑦施工完成：24小時後方可上人，72小時後可重壓。
The construction is completed: 24 hours later, the upper body can be weighed after 72 hours.