环氧樹脂地坪【环氧地坪】性能好壞如何區分

目前，大多數廠傢在選擇做廠房环氧地坪時都會考慮做环氧地坪，而這也正是由环氧地坪的特殊性能來決定的。但是哪一種环氧地坪好，哪一種环氧樹脂地坪不好，也是一個很令人頭疼的問題。今天，我們就教大傢如何來區分环氧樹脂地坪的好壞。环氧地坪是一種高強度、耐磨損、美觀的地板，具有無接縫、質地堅實、耐藥品性佳、防腐、防水、防塵、保養方便、維護費用低廉等優點。可根據不同的用途要求設計多種方案，如0.5mm厚薄層塗裝、1-5mm厚的自流平地面、防滑耐磨塗裝、砂漿型塗裝、防靜電、防腐蝕塗裝等。通常，為瞭分辨环氧樹脂地坪性能好壞可以從以下幾方面做起：
At present, most manufacturers will consider making epoxy flooring when choosing to make factory floor, which is also determined by the special performance of epoxy flooring. But which kind of epoxy floor环氧地坪ing is good and which kind of epoxy flooring is bad is also a very headache. Today, we will teach you how to distinguish the quality of epoxy resin floor. Epoxy floor is a kind of high strength, wear-resistant and beautiful floor. It has many advantages, such as seamless, solid texture, good resistance to drug, anti-corrosion, waterproof, dust-proof, convenient maintenance and low maintenance cost. Various schemes can be designed according to different application requirements, such as 0.5mm thick and thin coating, 1-5mm thick self-leveling floor, anti-skid and wear-resistant coating, mortar coating, anti-static, anti-corrosion coating, etc. Usually, in order to distinguish the performance of epoxy resin floor, we can start from the following aspects: 一、機械性能要求 主要以下三個方面： 1. 耐磨性：环氧地坪在使用時會有哪些車輛行走? 2. 耐壓性：地坪在使用時會承受多大荷載? 3. 耐沖擊性：沖擊力是否會引起地坪面剝離?
First, mechanical performance requirements are mainly in the following three aspects: 1. Wear resistance: when the floor is in use, which vehicles will walk? 2. Pressure resistance: how much load the floor will bear in use? 3. Impact resistance: will the impact force cause the floor to peel off?
二、化學性能要求 主要考慮以下兩個方面： 1. 耐酸堿性：使用時腐蝕性化學物質的種類及濃度。2. 耐溶劑性：使用時溶劑類型及接觸時間。
2. Chemical performance requirements mainly consider the following two aspects: 1. acid and alkali resistance: the type and concentration of corrosive chemicals in use. 2. solvent resistance: solvent type and contact time.
三、樓層位置狀況 根據地坪是在地下樓層還是地面樓層的位置，確定是否需要防潮處理或選擇特殊防潮地坪?
3. Floor location. According to whether the floor is in the ground floor or the ground floor, is it necessary to choose a special moistureproof or moistureproof?
四、基面狀況 1. 基層強度：一般要求抗壓強度≥20Mpa
Four, base level 1. base strength: General requirements for compressive strength greater than 20Mpa
2. 平整度：是否需要用环氧砂漿修補?
2. Flatness: is it necessary to repair with epoxy mortar?
3.地面施工前一般需要用自流平處理
3. self leveling is usually required before surface construction.
五、美觀要求 1. 顏色要求：是否需要顏色劃分區域?
Five, aesthetic requirements 1. color requirements: is it necessary to partition the color area?
2. 亮度要求：是選擇啞光還是亮光?
2. brightness requirement: choose matte or bright?
3. 平整度要求：是否對地坪的平整度有要求?
3. flatness requirement: is there any requirement for the smoothness of the floor?
六、安全性要求 如果地坪處在油漬环境或坡道處，則需要選擇防滑地坪。
Six, safety requirements if the floor is located in the oil contaminated environment or ramp, we need to choose the anti slip floor.
七、 施工工藝： A、环氧樹脂防靜電自流平地坪漆施工工藝：1、基面處理;2、 滾刷防靜電底油;3、 鋪設導電銅網;4、 批刮防靜電砂漿中塗;5、 批刮防靜電膩子;6、 鏝刮防靜電自流平面塗。
7. Construction technology: A. Construction technology of epoxy resin anti-static self-leveling floor paint: 1. Base surface treatment; 2. Rolling brush anti-static base oil; 3. Laying conductive copper mesh; 4. Batch scraping anti-static mortar coating; 5. Batch scraping anti-static putty; 6. Batch scraping anti-static self-leveling surface coating.
B、环氧樹脂防靜電滾塗地坪漆施工工藝：1、 基面處理;2、 滾刷防靜電底油;3、 鋪設導電銅網;4、 批刮防靜電砂漿中塗;5、 批刮透水地坪防靜電膩子;6、 滾刷防靜電面塗或噴塗防靜電面塗。
B. Construction technology of anti-static rolling epoxy floor paint: 1. Base surface treatment; 2. Anti-static rolling base oil; 3. Laying conductive copper mesh; 4. Batch scraping anti-static mortar coating; 5. Batch scraping anti-static putty; 6. Rolling brushing anti-static surface coating or spraying anti-static surface coating.
C、环氧樹脂自流平地坪漆1、 基面處理;2、 滾刷底油;3、批刮砂漿中塗;4、批刮膩子;5、鏝刮自流平面塗。
C, epoxy resin self-leveling floor paint 1, base surface treatment; 2, rolling brush base oil; 3, batch scraping mortar coating; 4, batch scraping putty; 5, upsetting self-leveling floor paint.
D、环氧樹脂滾塗地坪漆1、基面處理;2、滾刷底油;3、批刮砂漿中塗(0.3-0.5mm厚型無此層)4、批刮膩子;5、滾刷面塗，亦可噴塗面塗或面層做防滑工藝
D, Epoxy Resin Rolling Floor Paint 1, Base Surface Treatment; 2, Rolling Brush Base Oil; 3, Batch Scraping Mortar Intermediate Coating (0.3-0.5mm Thick Type without this Layer); 4, Batch Scraping Putty; 5, Rolling Brush Surface Coating, Spraying Surface Coating or Surface Coating for Anti-skid Technology