环氧地坪翻新前怎麼將舊的地面漆處理幹凈?

文章时间:2018-11-03 22:16:03   浏览次数:1170

每個环氧地坪使用到一定周期後都會出現損耗,這個時候就需要我們去修補或者翻新环氧地坪瞭。下面地億建設來講講环氧地坪怎麼去除舊面漆?因环氧地坪使用時間太長或者使用過程中有刮傷的原因,环氧地坪或多或少都會有一部分損壞,令大傢最頭疼的問題,莫過於是處理舊环氧塗層瞭。在更換之前肯定要把以前就的清除掉的,但是如何清理舊的环氧地坪也不是一件容易的事情,要使用科學的方法,再加上相應的設備才可以很好的清除。清除舊环氧环氧地坪施工方案如下:
Every epoxy floor will be damaged after a certain period of use, at this time we need to repair or renovate the floor. Below 100 million construction to talk about how to remove the old coat of epoxy floor paint. Because the epoxy floor has been used for too long or scratched in the process of use, it will be damaged more or less. The most headache for everyone is to deal with the old epoxy coating. Before replacing, we must clear the old epoxy floors, but how to clean up the old epoxy floors is not an easy task. It is necessary to use scientific methods, coupled with the corresponding equipment, to clean up the old epoxy floors well.
The construction plan for removing the old epoxy floor is as follows:
1.機械除漆法:采用研磨機和銑刨機進行處理。
1. mechanical lacquer removal: grinding machine and milling machine for processing.
1mm以下的舊环氧地面可以使用中、重型研磨機配合粗磨盤進行打磨處理,去除舊环氧油漆;
Old epoxy floors under 1 mm can be ground with medium and heavy grinding machines and rough grinding discs to remove old epoxy paint.
1mm以上的环氧砂漿必須使用銑刨機來除砂漿層,根據舊地面的厚度可調節銑刨機深度,配合研磨機使用可提高工作效率。
The epoxy mortar above 1mm must be removed by milling machine. The depth of milling machine can be adjusted according to the thickness of the old ground. The working efficiency can be improved by using the milling machine together with the grinding machine.
2.手動鏟除法:用手磨機手動清除,缺點是花費時間較長;
2. manual shovel Division: manual removal by hand mill, the disadvantage is that it takes a long time.
脫漆劑溶解或其他酸堿性化學品溶解:將調配混合好的堿液脫漆劑直接用塗刷在舊地坪漆表面,等把地坪漆塗膜腐蝕破壞掉,再用鏟刀清除舊塗膜。
Dissolution of pain印花地坪t remover or other acidic and alkaline chemicals: The mixed alkali solution paint remover is directly applied to the surface of the old floor paint, and the coating is corroded and destroyed, then the old coating is removed with a spatula.
3.堿液除漆法詳細的操作流程:
3. the detailed operation procedure of alkali removing paint method:
1 )先把堿液脫漆劑加入溶解,均勻攪拌直至均勻溶解稱為糊狀。
1) first, remove the paint from the lye and add it to the solution, stirring evenly until it is dissolved evenly. It is called paste.
2) 將調配混合好的堿液脫漆劑直接用塗刷在舊地坪漆表面,刷塗2-3道。
2) mix the good alkali paint remover directly on the old floor paint and brush 2-3.
3 )大概2-5小時後,堿液脫漆劑會把地坪漆塗膜腐蝕破壞掉,再用鏟刀清除舊塗膜。
3) After about 2-5 hours, alkali paint stripper will corrode and destroy the floor paint film, and then remove the old paint film with a spade.
4 )如果有清除不掉的塗膜再次塗堿液脫漆劑除去,或者用打磨機打磨掉。
4) if there is a coating that can not be removed, the paint will be removed once more, or polish with the grinding machine.
4.使用拋丸機打磨,這個方法也叫拋丸除漆法:
4. the use of shot blasting machine grinding, this method is also called shot blasting paint removal method:
1)、使用機械:拋丸機
1) use machine: shot blasting machine.
2)、優點:去除地坪漆舊塗膜徹底。
2), advantage: remove floor paint and old coating thoroughly.
3)、缺點:容易將沒損壞的舊塗膜一起打磨清楚,會造成一定浪費。
3) disadvantage: it is easy to polish the old film without damage, resulting in a certain waste.
4)、註意事項:拋丸機是接電運作,底部是高速彈射的彈丸,如果打磨機轉向時不註意打磨到電線,將會造成安全事故。
4) Notes: The shot blasting machine is connected to electricity, the bottom is high-speed ejection projectile, if the grinder does not pay attention to grinding the wire when turning, it will cause safety accidents.
5.火焰去除法:其中常用的是噴燈火焰除漆法。
5. flame removal: one of the 透水地坪most common uses is torch flame and paint removal.
這種方法的優點是火焰去除法中最為經濟實惠和簡單的方法,並且安全可靠。火焰去除法的通用原理就是利用瞭高溫使得漆膜軟化,凸起,然後在進行刮鏟的辦法。
The advantage of this method is that it is the most economical and simple method in flame removal method, and it is safe and reliable. The general principle of flame removal is to use high temperature to soften, bulge and scrape the paint film.
翻新舊环氧地坪一定要把面漆清理處理幹凈,不然會影響下面的工序,最後成品肯定不是自己想要的。要用正確科學的方法解決問題,不要自己想象做事。
Renovation of the old epoxy floor must be cleaned up, or it will affect the following process, the final product is certainly not what you want. We should solve problems in correct and scientific way, and do not imagine ourselves doing things.