工業环氧地坪怎樣進行驗收？

我們都在工商業場所使用工業环氧地坪，這是因為需要增強混凝土地面的耐磨性能。這樣不僅提高瞭混凝土表面的密度，使其減少起塵，增加瞭城面的防油性，形成一個高密度，易清潔，抗滲透的地面。而且與混凝土地面一起施工，施工工期短。造價低廉耐久性好，減少周期性塗裝或將表面增厚所帶來的費用， 這是我們選擇环氧地坪的原因。
We all use industrial epoxy flooring in industrial and com印花地坪mercial places because of the need to enhance the wear resistance of concrete flooring. This not only improves the density of the concrete surface, reduces dust, increases the oil resistance of the city surface, and forms a high density, easy to clean and anti-permeability ground. And with the concrete floor construction, construction period is short. Low cost and good durability, reduce the cost of periodic coating or surface thickening, which is why we choose epoxy flooring. 表面性能：
Surface properties:
1、环境溫度為25℃時，施工後2-3天應達到實幹，即硬度達到完成固化的80%左右；
1. When the ambient temperature is 25 C, the hardness should reach about 80% of the solidification after 2-3 days of construction.
2、表面不能出現發粘現象；
2, the surface can not appear sticky phenomenon;
3、氣泡：平塗型、砂漿型無氣泡，自流平允許1個小氣泡/10平方米；
3, bubble: flat coated, mortar type no bubbles, self leveling allows 1 small bubbles /10 square meters;
4、流平性好，無鏝刀痕，大面積接口處基本平整;
4, good leveling, no trowel marks, large area of the interface is basically smooth.
5、無浮色發花，顏色均勻一致，大面積接口處允許有極不明顯的色差；
5, no floating color and flower, uniform color, large area interface allows very insignificant chromatic aberration;
6、無粗雜質，但允許有空氣中的浮塵掉落在造成的極小缺陷；
6, there is no coarse impurity, but it allows the floating dust in the air to drop into the minimal defect.
7、环氧地坪表面應平整平滑，光澤度應達到設計要求（高光澤≥90、有光≥70、半光50～70），平塗型為有光、水性為半光～無光；
7. The surface of the floor should be s环氧地坪mooth and smooth, and the glossiness should meet the design requirements (high gloss (> 90), gloss (> 70), half gloss (> 50-70). The flat coating type should be glossy and water-based should be half glossy (~dull).
8、桔皮、砂漿防滑面效果應很明顯。
8, orange peel and mortar anti slip surface effect should be very obvious.