桔紋型环氧地坪漆施工時需要註意哪些問題

桔紋环氧地坪漆，產品的环氧地坪漆由主漆和固化劑組合而成，產品的主漆中含有有機膨潤土和氣相二氧化矽。本產品產品的环氧地坪漆，采用有機膨潤土和氣相二氧化矽搭配作為觸變劑，使得配漆後的漆液觸變性穩定不變或變化不明顯，從而保證瞭漆液凝膠前的不同時間裡，所制作的花紋都是均勻一致的。本產品產品的地坪漆用於要求地面需要較高耐磨性、防滑性或者需要類桔皮表面凸凹美感的地坪場合，解決在施工時限內保證桔皮花紋不受時間限制影響，不受搭接施工的影響。
Orange pattern epoxy floor paint, the product floor paint is composed of the main paint and curing agent, the main paint of the product contains Organobentonite and fumed silica. The floor paint of this product is made of organo bentonite and fumed silica to be used as thixotropic agent, so that the paint liquid after coating is stable and unchanged or the change is not obvious, thus ensuring that the patterns made are uniform and uniform at different times before the gel. The floor paint of this product is used in the ground which requires high wear resistance, skid resistance or the convex and concave aesthetic feeling of orange peel surface. It can solve the problem that the orange peel pattern is not affected by time limit and overlap construction. 基礎處理 1、用研磨機進行全面打磨。讓破損、起沙、粘度不牢、開裂、空鼓之部位完全暴露出來；並將浮起的砂漿、舊环氧水泥結塊等打磨平整。 2、有松動、裂縫或脫層的地面，必須徹底打磨至密實基層，保證地面的粘結度 3、將基層表面的浮灰、污染物等垃圾清理幹凈，確保基層表面的幹凈度。 重慶桔紋环氧地坪漆施工 4、將處過的地面清潔。 檢驗环氧地坪方法：經處理後，地坪表面平整、密實、幹燥，無油污、且沒有松動易碎顆粒，方可進行地坪漆下一工序施工。 伸縮縫、裂縫、空鼓地面、松動舊环氧的特殊處理 1、對開裂之部位采用切割片切成V型小槽後，再用高倍中塗砂漿予以修補填平；細小的裂縫可以用环氧樹脂加增稠劑修補；待完全固化後再用手磨機細打至平整。 2、對空鼓、舊环氧松動之部位鑿除，如凹糟較深，采用高倍中塗砂漿予以補平，完全固化後再用手磨機細打至平整。 3、所有特殊場地修補處理後，再清潔一遍。
Foundation treatment 1, grinding machine for comprehensive grinding. Let the damaged, sand, viscosity is not strong, cracking, hollow parts exposed completely; and floating mortar, old epoxy cement agglomeration and other smooth grinding. 2. Ground with looseness, cracks or delamination must be thoroughly ground to a dense base to ensure the cohesion of the ground 3, the base surface of the floating ash, pollutants and other garbage clean, to ensure the cleanliness of the base surface. Chongqing orange pattern epoxy floor paint construction 4, clean the floor. Inspection methods: After treatment, the surface of the floor is smooth, compact, dry, no oil pollution, and there is no loose and fragile particles before the next process of floor paint construction. Extensio印花地坪n joints, cracks, hollow floor, loose old epoxy special treatment 1, the cracked parts are cut into V-shaped grooves, and then repaired with high-power mortar; small cracks can be repaired with epoxy resin thickener; after fully cured, then fine-beaten with hand mill to smooth. 2. Cut out empty drum and old epoxy loose parts, if the concave grains are deep, use high-power middle-coated mortar to flatten, fully solidified and then fine-beat with hand mill to flatten. 3. All special sites should be cleaned once again after repair.