环氧地坪具有哪些優勢以及自流平地坪保養

环氧地坪因為品質好,所以一直以來很受廣大消費者歡迎,那麼环氧地坪有哪些優勢呢!以及自流平环氧地坪保養方法是怎樣的那?相信大傢看完這篇文章的介紹以後也已經瞭解瞭,希望這篇文章的解答能給您帶來幫助。环氧地坪有哪些優勢?
Epoxy floor because of good quality, so has been very popular with the majority of consumers, then what are the advantages of epoxy floor! And leveling floor maintenance method is what? I believe you read this article after the introduction has also been understood, I hope the answer to this article can help you. What are the advantages of epoxy floor?
室溫固化的水性环氧樹脂塗料體系一般分為四類:Ⅰ型水性环氧樹脂體系,由低分子量的液體环氧樹脂(环氧當量在 190左右)和水性环氧固化劑組成,這類體系中的环氧樹脂一般預先不乳化,而由水性环氧固化劑在使用前混合乳化,因而這類固化劑必須既是交聯劑又是乳化 劑,它能夠很好地分散或溶解在水中,從而對低分子量的液體环氧樹脂具有良好的乳化作用,可配成零VOC塗料,塗膜硬度增長較快;Ⅱ型水性环氧樹脂體系,由 高分子量的固體环氧樹脂乳液和水性环氧固化劑組成,由於高分子量环氧樹脂的反應活性較低分子量环氧樹脂小,因此Ⅱ型水性环氧樹脂體系的適用期較Ⅰ型長、表 幹時間較Ⅰ型短;
Room temperature curable waterborne epoxy resin coatings are generally divided into four categories: Type I waterborne epoxy resin system, consisting of low molecular weight liquid epoxy resin (epoxy equivalent around 190) and waterborne epoxy curing agent, in which the epoxy resin is generally not pre-emulsified, but is mixed with waterborne epoxy curing agent before use, and therefore emulsified. This kind of curing agent must be both a cross-linking agent and an emulsifier. It can be well dispersed or dissolved in water, thus having good emulsification for low molecular weight liquid epoxy resin, and can be made into zero VOC coating. The hardness of the coating increases rapidly. Oxygen curing agent composition, due to the lower reactivity of high molecular weight epoxy resin, low molecular weight epoxy resin, so type II waterborne epoxy resin system is longer than type I, surface drying time is shorter than type I.
固化效果是衡量水性體系產品的重要指標。水性环氧樹脂體系的固化成膜機理 水性环氧樹脂塗料是一種乳液塗料,其成膜機理與一般的聚合物乳液塗料如丙烯酸乳液的成膜有很大的區別,同時與溶劑型环氧樹脂塗料的成膜也不完全相同。對於 水性环氧樹脂塗料,其固化是否充分主要取決於以下兩個因素:一是环氧樹脂分散相粒子的粒徑,在保證水性环氧固化劑用量相同的情況下,环氧樹脂分散相粒子的 粒徑較小時,粒子表面的固化劑濃度較為適中,表面固化速度較慢,固化劑分子有足夠的時間擴散到整個环氧樹脂分散相粒子,使之固化完全,因而可以形成均勻、 完全固化的塗膜;二是环氧固化劑與环氧樹脂的相容性,提高环氧固化劑與环氧樹脂的相容性,有利於水性环氧樹脂乳液分散後體系的穩定性,並且兩者的相容性越好,环氧固化劑越容易向环氧樹脂微粒內部擴散,有利於固化反應的進行。
Curing effect is an important index to measure the product of waterborne system. Waterborne epoxy resin curing film forming mechanism waterborne epoxy resin coating is an emulsion coating. Its film forming mechanism is quite different from that of general polymer emulsion coatings, such as acrylic emulsion, and is also not identical with that of solvent based epoxy resin coatings. For waterborne epoxy resin coatings, whether the curing is sufficient depends on the following two factors: first, the particle size of epoxy resin disperse phase, in the case of ensuring the same amount of waterborne epoxy curing agent, the particle size of epoxy resin disperse phase is smaller, the particle surface curing agent concentration is more moderate, the surface curing speed is slower. The curing agent has enough time to diffuse into the entire epoxy resin dispersed phase particles, so that it can be cured completely, thus forming a uniform and completely cured coating. Two, the compatibility between epoxy curing agent and epoxy resin, and the compatibility of epoxy curing agent with epoxy resin is improved, which is conducive to the stability of waterborne epoxy resin emulsion after dispersion. The better the compatibility of the two, the easier the epoxy curing agent to diffuse into the epoxy resin particles, which is conducive to the curing reaction.
环氧自流平
Epoxy self leveling
环氧自流平地坪保養:
Epoxy self leveling floor maintenance:
1、拖拉機扳需充分將機板升離地面,轉彎時請特別註意機板角切勿刮傷地面。
1. The tractor pull should lift the board off the ground sufficiently. When turning, please pay special attention to the angle of the board and do not scratch the ground.
2、清潔地面時請用軟質吸水性好的拖把或幹濕兩用吸塵器,可用清水或清潔劑清洗,但請註意地面濕滑。
2. When cleaning the ground, please use soft mop or dry-wet dual-purpose vacuum cleaner. Clean it with clean water or detergent, but pay attention to the wet and slippery ground.
3、設備進廠前,在环氧地坪上鋪上硬紙箱墊底,以免在運輸設備過程中刮傷地面。
3, before entering the factory, lay the bottom of the floor with cardboard boxes to avoid scratching the floor during 彩色沥清地坪transportation.
4、推車,板車之車輪請用硬質或彈性膠輪,並廠房內外分開使用8、可根據地面要求做打蠟處理(其效果可防止地面刮傷)。
4. Use hard or elastic rubber wheels for wheels of trolleys and boards, and use them separately inside and outside the factory building. Waxing treatment can be done according to the ground requirements (the effect can prevent ground scratches).
5、坪地施工完畢後需養護7-10天後方可投入使用,在養護期間,應避免水或其它溶液浸潤表面。
5. The ground should be maintained for 7-10 days before it can be put into use. During the maintenance period, water or other solution should be avoided to soak the surface.
6、凡進入車間員工必須要換成膠底鞋(不可以穿泡沫底的黑底鞋)(以免將外面的泥沙帶入車間而劃傷地面)。
6, anyone entering the workshop must have rubber shoes (not wearing black shoes with foam bottom), so as not to bring sand outside into the workshop and scratch the ground.
7、凡是硬件:如鐵椅、鐵桌、鐵貨架等,須將其腳用軟質塑料、橡膠包裹或用紙皮墊起來以免在使用過程中劃傷地面。
7. All hardware, such as iro印花地坪n chairs, iron tables, iron shelves, etc., should be soft plastic, rubber wrapped or padded with paper to avoid scratching the ground in use.