完美的水性环氧地坪漆需要滿足哪些條件

在民眾环保意識日漸增強的今天，水性环保化已成為塗料行業的發展方向，但相對油性环氧地坪漆，水性环氧地坪漆對施工技能及施工环境的要求較高，否則難以保證环氧地坪工程質量。那水性环氧地坪漆對施工环境有哪些要求呢？地坪施工是一個系統性的工程，需要從底到面控制好每一步，才幹保證整個环氧地坪工程的質量。當然，挑選好的地坪漆施工工人會讓你的地坪施工辦理起來更省時省力哦。
Nowadays, with the increasing awareness of environmental protection, water-borne environmental protection has become the development direction of the coating industry. However, compared with oily floor paint, water-borne epoxy floor paint requires higher construction skills and construction environment, otherwise it is difficult to ensure the quality of floor engineering. What are the requirements of the waterborne epoxy floor paint for the construction environment? Floor construction is a systematic project, it needs to control every step from bottom to surface to ensure the quality of the entire epoxy floor project. Of course, the selection of good floor paint workers will make your floor construction process more time-saving and labor-saving.
一、 施工底漆前需將地上水泥砂漿剔鑿並清掃潔凈，地上如有油脂類雜質，應用溶劑擦洗潔凈防止附著不良；原水泥地上要求堅固、平坦、不起砂，地上如有空鼓、脫皮、起砂、裂痕等，有必要按要求處理後方可施工；
1. Before the primer is applied, the cement mortar on the ground should be chiseled and cleaned. If there are oil and grease impurities on the ground, the solvents should be used to scrub and clean the ground to prevent bad adhesion.
二、假如為水磨石、地板磚等潤滑地上，須先打磨成 糙面；
Two. If the ground is lubricated on terrazzo and floor tiles, the rough surface must be ground.
三、地坪漆基面應平坦，無積水或無明顯滲漏現象；
Three. The floor surface of floor paint should be flat without water accumulation or obvious leakage.
四、施工時現場相對濕度應低於65%，防止粉塵吹入污染加工區.基面含水率有必要小於8%，並無明顯“返潮”現象。
4. Relative humidity should be lower than 65% during construction to prevent dust 环氧地坪from blowing into the polluted processing area. It is necessary that the moisture content of the base surface should be less than 8%, and there is no obvious "moisture regain" phenomenon.
五、為瞭防止施工邊際部分沾污及加工處保持徹底直線或與不塗部分的界限應貼好護面膠帶。
5. In order to prevent the contamination of the construction margin and maintain a complete straight line at the processing place or the boundary with the uncoated part, the protective tape should be affixed.
六、环境溫度在12℃以上，防止固化程度過低，使塗膜性能下降。嚴禁印花地坪穿插施工、無關人員進入施工現場。搬運到施工現場的資料，必須放在可以防止風、雨及陽光直射的當地。並做好防火徹底辦法。
Six, the ambient temperature is above 12 C, so that the curing degree is too low, and the performance of the coating decreases. It is strictly prohibited to interlude construction and unrelated personnel to enter the construction site. The information to be carried to the construction site must be placed in areas where wind, rain and sunlight can be prevented. And do a good job of fire prevention.