列管式冷凝器部分和使用范圍解讀

冷凝器銷售采用端面馬蹄形磁力攪拌器，完全靜密封、無泄漏，耐高溫、高壓、高真空、攪拌轉速高、運行平穩、噪音小、適用范圍廣、使用簡單、操作方便等特點，是實驗室進行各種攪拌反應的理想設備。冷凝器適用於反應物料粘度小的液體、氣體等介質在不同的反應條件下進行攪拌反應，不適用於粘度大的、帶固體料或產生結晶的介質進行攪拌反應。主要用於氣體與液體反應、氣體與氣體反應、液體與固體反應。攪拌軸承采用耐腐蝕不銹鋼或陶瓷球軸承。
Condenser sales use end horseshoe-shaped magnetic mixer, completely static seal, no leakage, high temperature, high pressure, high vacuum, high mixing speed, smooth operation, low noise, wide range of application, simple use, easy operation and so on. It is the ideal equipment for various mixing reactions in the laboratory. Condenser is suitable for stirring reaction of liquid and gas with low viscosity of reaction material under differe印花地坪nt reaction conditions. It is not suitable for stirring reaction of透水地坪 medium with high viscosity, solid material or crystallization. Mainly used for gas and liquid reaction, gas and gas reaction, liquid and solid reaction. Stirring bearings are made of corrosion-resistant stainless steel or ceramic ball bearings.冷凝器銷售釜體部分
Condenser sales kettle body part
1.釜體部分由圓筒和上、下封頭組成，提供物料化學反應的空間，其容積由生產能力和產品的化學反應要求決定。
1. The kettle body is composed of a cylinder and upper and lower heads, which provides space for chemical reaction of materials. Its volume is determined by production capacity and chemical reaction requirements of products.
2.中、低壓筒體通常采用不銹鋼板卷焊，也可采用碳鋼或鑄鋼制造，為防止物料腐蝕，可在碳鋼或鑄鋼內表面襯耐蝕材料。
2. Medium and low pressure cylinders are usually welded with stainless steel sheets or made of carbon steel or cast steel. In order to prevent material corrosion, corrosion resistant materials can be lined on the inner surface of carbon steel or cast steel.
3.釜體殼能同時承受內部介質壓力和夾套壓力，必須分別按內、外壓單獨作用時的情況考慮，分別計算其強度和穩定性。
3. The shell of the kettle can withstand both the internal medium pressure and the jacket pressure. The strength and stability of the kettle must be calculated separately according to the condition of the internal and external pressure acting alone.
4.對於承受較大外壓的薄壁筒體，在筒體外表面影設置加強圈。
4. For the thin-walled cylinder under large external pressure, a stiffening ring is arranged on the outer surface of the cylinder.

冷凝器銷售使用范圍
Sales scope of condenser
1）不適於PH值大於12且溫度高於80°C的堿性介質或物料。
1) It is not suitable for alkaline media or materials with PH value greater than 12 and temperature higher than 80 degree C.
2）不適於酸堿物料交替進行的反應過程。
2) It is not suitable for the alternating reaction of acid-base materials.
3）冷凝器不適於在溫度劇變化時，所產生過大的應力會導致爆瓷而損壞設備,因此在使用過程中應升溫或降溫，嚴防聚冷聚熱。
3) Condenser is not suitable for the rapid change of temperature, the excessive stress will lead to the explosion of porcelain and damage the equipment, so in the use process should be heated or cooled, strictly prevent the condensation of cold and heat.
4）不適於任何濃度和溫度的氫氟酸及含有氟離子的介質或物料。
4) Hydrofluoric acid and media or materials containing fluoride ions which are not suitable for any concentration and temperature.
5）不適於濃度大於30%，溫度大於180°C度磷酸介質或物料。
5) It is not suitable for phosphoric acid medium or material whose concentration is more than 30% and temperature is more than 180 degrees C.
辛苦整理！轉載請註明來自http://www.zqshzb.com/n1b/3028.html